Our board include Light and Motion Sensor and Light Sensor together on one TLSR8258 board.
I want to use SigMesh SDK on this board.
I found below on /vensor/common/sensors_model.h
#define SENSOR_NUMS 1 // support only 1 now
How to support 2 sensors(Motion and Light sensor together) ?
Confirm that only one sensor can work properly and meet expectations for a development board, and then consider the scenario where one development board supports two sensors. Telink currently only supports one sensor for one development board
发表于 2024-10-28 11:11:40
发表于 2024-11-1 15:38:20